狠狠色综合7777久夜色撩人ⅰ丨国产精品日韩欧美一区二区三区丨亚洲精品理论丨可以看av丨97公开视频丨日本高清无卡码一区二区丨性生活av丨成年在线观看免费视频丨日韩免费一级丨久久精品丝袜丨国产香蕉尹人视频在线丨日日躁夜夜躁人人揉av五月天丨亚洲伦理在线视频丨国产777爽777丨亚洲精品国产情侣av在线丨亚洲第1页丨免费视频福利丨天堂av在线免费观看丨制服 丝袜 有码 无码 中文丨亚洲第一综合网站丨天天摸天天插丨欧美jizzhd精品欧美喷水丨xxx在线播放丨亚洲成av人影院在线观看网丨成人网在线

      Rubber products differ from other engineering materials in that the processing process of rubber products usually faces many unique problems which are different from the common problems of other non-rubber materials in the processing process. So today we talk in detail about some of the main problems existing in the production process of rubber products, which may lead to problems and solutions!

1. Rubber products are too rough

Cause analysis: 

1. The mold surface is rough and not cleaned

2. The coke burning time of mixing glue is too short.

    Solution: clean the mold; Prolong the burning time.

2, rubber products rubber edge is too thick, the product is overweight

Cause analysis: 

1. Too much plastic material in the mold

2. Insufficient plate pressure

3. There is no corresponding residual groove in the mold.

Solution: 

1. Strictly control the unit consumption of semi-finished products

2. Increase plate pressure

3. Improve mold design.

3, rubber products have bubbles

Cause analysis: 

1. There are impurities or oil stains in the mold or rubber material.

2. Insufficient curing.

3. Not enough stress.

4. Vulcanized mold temperature is too high.

5 curing agent added less, curing speed is too slow.

Solutions: 1. Pressure

 2. Lengthen the sulfur 

3. Adjust the formula, speed up the vulcanization.

4. Exhaust more. 

5. The mode temperature cannot be too high. 

6. Increase the dosage of vulcanizing agent.

4, rubber products tear

Reason analysis: 

1. Vulcanization speed is too fast, the glue flow is not sufficient. 

2. The mold is dirty or the glue is sticky.

3. Too much isolator or release agent. 

Solution: 

1.Reduce the mold temperature and slow down the vulcanization speed.

2.Keep the glue. Mold cleaning.

3. Use less isolation agent or release agent. 

4. The glue is thick enough.

5, rubber products lack of glue

Cause analysis: 

1. The rubber material does not flow fully;

2. Insufficient single consumption of semi-finished products or insufficient glue loading;

3.  Poor exhaust performance of the die; Mold temperature is too high

Solution: 

1. Slow down the mold rising speed and repeatedly deflate;

2. Reformulate the mold filling amount;

3. Improve mold design and reduce mold temperature.